Page 81 - Cable Art Inc Catalog

Non-Tensioning Fittings NON-TENSIONERS

CAI Fixed Jaw
“A”

FERRULE “G”
“J”
For use on level runs and on stairs and severe pitches.
Often used with the Adjust-A-Jaw tensioner (page 43)
®
because it is shaped to match the clevis end on the
Adjust-A-Jaw tensioner but is less costly.
Use threaded tabs or lag eyes (page 88) to mount the “S”
CAI Fixed Jaw fittings to the end posts, or mount them “L” ONE SIDE ONLY
using flat bar or angle iron welded to the post with holes
drilled to accept the clevis.

CAI FIXED JAW SWAGE 316SS
CABLE PART USE WITH USE WITH “A” “S”
DIA. NO. FERRULE NO.* SCREW NO.* DIA. THREAD ”G” “J” “L”
1/8" 20FFJ4 20FF4 11HBS8 .260" 1/4"-28 .260" .56" 1.75"
3/16" 20FFJ4 20FF6 11HBS8 .260" 1/4"-28 .260" .56" 1.75"
1/4" 20FFJ8 20FF8 11HBS12 .390" 3/8"-24 .313" .75" 2.12"
5/16" 20FFJ10 20FF10 11HBS12 .390" 3/8"-24 .348" .87" 2.25"
3/8" 20FFJ10 20FF12 11HBS12 .390" 3/8"-24 .348" .87" 2.25"
*Order Ferrule (page 45) and Screw (page 43) separately. Also available in Black Oxide finish.

CAI Clip-on Fixed Jaw

Same as the CAI Fixed Jaw fitting except the cable is attached to the fitting with
a special clip that is installed on site by hand. The cable is supplied by the factory
with a tensioner on one end and a ferrule on the other end. There is no field
swaging. Slip the ferrule end of the cable through the body of the fixed jaw, slip
on the special clip, then pull the cable back through the body to secure the cable
inside. Check with the factory to determine cable lengths to be supplied with
swaged fittings. Available for 1/8” and 3/16” cable only.

“A”
CLIP

FERRULE “G”
“J” SWAGED NON-TENSIONERS

CAI CLIP-ON FIXED JAW See Fixed Jaw drawing above. SWAGE 316SS
CABLE PART USE WITH USE WITH “A” “S”
DIA. NO. FERRULE NO.* SCREW NO.* DIA. THREAD “G” “J” “L”
1/8" 20ACFJ4 20FF4 11HBS8 .260" 1/4"-28 .260" .56" 1.75"
“S”
20FF6
“L” 3/16" 20ACFJ6 ONE SIDE ONLY 11HBS8 .260" 1/4"-28 .260" .56" 1.75"
*Order Ferrule (page 45) and Screw (page 43) separately. Also available in Black Oxide finish.

69

Cat21 S4 68-73.indd 69 12/3/20 12:14 AM