Handy Crimp Toggle Jaw (3/16") - (Import)

1/8" Handy Crimp Toggle Jaw Turnbuckle

3/16" Handy Crimp Toggle Jaw Turnbuckle

This is a multiple groove sleeve-pressing hand tool. This tool has two grooves (1/8" & 3/16") and is used on Handy Crimp fittings.

This simple cable tensioning system provides for an extremely "clean" look concealing the threads for adjustment internally. The Typical application is for short to medium length cable runs.

This simple cable tensioning system provides for an extremely "clean" look concealing the threads for adjustment internally. The Typical application is for short to medium length cable runs.

Deck Toggles provide a face mount solution while allowing for angled takeoff. These fittings are attached utilizing two screws through the Deck Toggle base. The articulation range of this Deck Toggle end fittings is greater than 180 degrees.

Deck Toggles provide a face mount solution while allowing for angled takeoff. These fittings are attached utilizing two screws through the Deck Toggle base. The articulation range of this Deck Toggle end fittings is greater than 180 degrees.

Deck Toggles provide a face mount solution while allowing for angled takeoff. These fittings are attached utilizing two screws through the Deck Toggle base. The articulation range of this Deck Toggle end fittings is greater than 180 degrees.

The Lag Stud has been developed for direct attachment to wood surface with a minimum of 3" of wood blocking for full thread engagement. Holes are simply pre-drilled into the connecting wood surface and the lag is threaded into the hole.

The Lag Stud has been developed for direct attachment to wood surface with a minimum of 3" of wood blocking for full thread engagement. Holes are simply pre-drilled into the connecting wood surface and the lag is threaded into the hole.

The "Lag" cable tensioning system has been developed for direct attachment to wood surface with a minimum of 3" of wood blocking for full thread engagement. Holes are simply pre-drilled into the connecting wood surface and the lag is threaded into the hole.

The "Lag" cable tensioning system has been developed for direct attachment to wood surface with a minimum of 3" of wood blocking for full thread engagement. Holes are simply pre-drilled into the connecting wood surface and the lag is threaded into the hole.

This fitting can be used with any tensioning device on the other end...but when used with our swageless tensioners, both ends can be put on the cable by hand without any swaging or special tools