6301 series stainless steel cable railing assemblies

Use on straight runs. (Not recommended for stairs or severe pitches.)

These are used where there is not sufficient space between the back of one of the end posts and where the other end does have sufficient space to install a Pull-Lock® fitting.

An Adjust-A-Body® with threaded eye tensioning device is supplied on one end. Mount the Adjust-A-Body® with threaded eye on one end, string cable through the intermediate posts and opposite end post, slide Pull-Lock® fitting on the cable and into the post. Tension the cable using an open-end wrench to tighten the Adjust-A-Body® with threaded eye tensioning device then cut-off excess cable from backside of the Pull-Lock® fitting and snap on the Stainless Steel Cap.

Order separately - P/N 11TCUTKIT, Cut-Off Tool for cutting the excess cable from the Pull-Lock® fitting and P/N 20HLE4 lag eye (for wood post) or P/N 20HTT4 threaded tab (for metal post) to provide means to attach the Adjust-A-Body® with threaded eye to the end post.

Click here for 6301 series Cable Assemby Instructions

Click here for our Cable Railing Assemblies How-To-Order Guide