4200 series stainless steel cable railing assemblies 2" long Receiver and Pull-Lock® fitting for use with end post greater than 1-1/2" width.

(Same as Ultra-tec® 232 SERIES)

Use on straight runs. (Not recommended for stairs or severe pitches.)

An Invisiware® Receiver tensioning device is supplied on one end. Install the receiver into one end post, string cable through the intermediate posts and opposite end post, slide Pull-Lock® fitting on the cable and into the post. Tension the cable by turning the Receiver using an Allen wrench, then cut-off excess cable from backside of the Pull-Lock® fitting and snap on the Stainless Steel Cap.

Order separately - P/N 11TCUTKIT, Cut-Off Tool at the bottom of this page for cutting the excess cable from the Pull-Lock® fitting.

Click here for 4200 series Cable Assemby Instructions

Click here for our Cable Railing Assemblies How-To-Order Guide

Click here for Installation Example