Pull-Lock® fittings are designed for use with 1x19 L.H. lay cable only. They can be used with any tensioning device on the other end...but when used with our swageless tensioners, both ends can be put on the cable by hand without any swaging or special tools.

If using with an 1-1/2" wide post, order (-12) Pull-Lock® to create a flush appearance on the inside of the post.

Pull-Lock® fittings are designed for use with 1x19 L.H. lay cable only. They can be used with any tensioning device on the other end...but when used with our swageless tensioners, both ends can be put on the cable by hand without any swaging or special tools.

If using with an 1-1/2" wide post, order (-12) Pull-Lock® to create a flush appearance on the inside of the post.

Push-Lock® fittings are designed for use with 1x19 L.H. lay cable only. They can be used with any tensioning device on the other end.

Push-Lock® fittings are designed for use with 1x19 L.H. lay cable only. They can be used with any tensioning device on the other end.

Push-Lock® fittings are designed for use with 1x19 L.H. lay cable only. They can be used with any tensioning device on the other end...but when used with our swageless tensioners, both ends can be put on the cable by hand without any swaging or special tools.

If using with an 1-1/2" wide post, order (-12) Push-Lock® to create a flush appearance on the inside of the post.

Push-Lock® fittings are designed for use with 1x19 L.H. lay cable only. They can be used with any tensioning device on the other end...but when used with our swageless tensioners, both ends can be put on the cable by hand without any swaging or special tools.

If using with an 1-1/2" wide post, order (-12) Push-Lock® to create a flush appearance on the inside of the post.

Push-Lock® fittings are designed for use with 1x19 L.H. lay cable only. They can be used with any tensioning device on the other end...but when used with our swageless tensioners, both ends can be put on the cable by hand without any swaging or special tools.

If using with an 1-1/2" wide post, order (-12) Push-Lock® to create a flush appearance on the inside of the post.

Push-Lock® fittings are designed for use with 1x19 L.H. lay cable only. They can be used with any tensioning device on the other end...but when used with our swageless tensioners, both ends can be put on the cable by hand without any swaging or special tools.

If using with an 1-1/2" wide post, order (-12) Push-Lock® to create a flush appearance on the inside of the post.

Push-Lock® Anchor Bolt(1/8")

Push-Lock® Anchor Bolt(3/16")

For level runs where the back side of the post is not accessible, so the cable must terminate in a fitting on the inside of the post, the Push-Lock® Lag (for wood posts with composite sleeves) addresses those needs.

For level runs where the back side of the post is not accessible, so the cable must terminate in a fitting on the inside of the post, the Push-Lock® Lag (for wood posts) addresses those needs.

For level runs where the back side of the post is not accessible, so the cable must terminate in a fitting on the inside of the post, the Push-Lock® Lag (for wood posts with composite sleeves) addresses those needs.

For level runs where the back side of the post is not accessible, so the cable must terminate in a fitting on the inside of the post, the Push-Lock® Lag (for wood posts) addresses those needs.

For level runs where the back side of the post is not accessible, so the cable must terminate in a fitting on the inside of the post, the Push-Lock® Lag (for wood posts) addresses those needs.