Use our fixed tabs or threaded tabs or lag eyes to mount Adjust-A-Jaw® tensioners to your end posts. Or you can mount them using flat bar or angle iron welded to your post with holes drilled to accept the clevis. See the tabulated drawing and chart below to determine how this fitting interfaces with your end post.

For use on 1/8" cable diameter.

Same as our CAI Fixed Jaw fittings, except the cable is attached to the fitting with a special clip that is installed on site by hand. The cable is supplied by the factory with a tensioner on one end and a ferrule on the other end. There is no field swaging.

For use on 3/16" cable diameter.

Same as our CAI Fixed Jaw fittings, except the cable is attached to the fitting with a special clip that is installed on site by hand. The cable is supplied by the factory with a tensioner on one end and a ferrule on the other end. There is no field swaging.

For use on 1/4" diameter cable.

Often used with our Adjust-A-Jaw® tensioner, because it is shaped to match the clevis end on the Adjust-A-Jaw® tensioner but costs considerably less. It can be used on level runs and on stairs and severe pitches.

For use on 1/8"" and 3/16" diameter cable.

Often used with our Adjust-A-Jaw® tensioner, because it is shaped to match the clevis end on the Adjust-A-Jaw® tensioner but costs considerably less. It can be used on level runs and on stairs and severe pitches.

For use on 5/16" and 3/8" diameter cable.

Often used with our Adjust-A-Jaw® tensioner, because it is shaped to match the clevis end on the Adjust-A-Jaw® tensioner but costs considerably less. It can be used on level runs and on stairs and severe pitches.

1/4" Ferrule

1/8" Ferrule

3/16" Ferrule

3/8" Ferrule

5/16" Ferrule

1/4" Cable Diameter.

Often used in combination with the Invisiware® receiver, this fitting is also hidden inside the end post with only the head exposed on the outside of the post. When installed, it looks the same as the Invisiware® receiver except it costs much less.

1/8" Cable Diameter.

Often used in combination with the Invisiware® receiver, this fitting is also hidden inside the end post with only the head exposed on the outside of the post. When installed, it looks the same as the Invisiware® receiver except it costs much less.

3/16" Cable Diameter.

Often used in combination with the Invisiware® receiver, this fitting is also hidden inside the end post with only the head exposed on the outside of the post. When installed, it looks the same as the Invisiware® receiver except it costs much less.

3/8" Cable Diameter.

Often used in combination with the Invisiware® receiver, this fitting is also hidden inside the end post with only the head exposed on the outside of the post. When installed, it looks the same as the Invisiware® receiver except it costs much less.