 |
Our Products
Shopping cart
Our services
|
|
Push-Lock® Tensioner with Threaded Bolt
- Push-Lock® Tensioner with Threaded Bolt
- How It Works
|
| Push-Lock® Tensioner with Threaded Bolt |
GRIP |
|
316SS |
CABLE
DIA. |
PART NO. |
"B"
BODY
LENGTH |
"D"
BODY DIA. |
"L"
LENGTH |
"T"
THREAD SIZE |
"X"
THREAD
LENGTH |
| OPEN |
CLOSED |
| 1/8" |
20APLTB4 |
3.820" |
.43" |
5.120" |
4.000" |
5/16" - 24 |
.500" |
| 3/16" |
20APLTB6 |
3.820" |
.43" |
5.120" |
4.000" |
5/16" - 24 |
.500" |
| Please click on part number to order. |
| Designed for use with 1x19 left hand lay strand only. |
|
 |
The Push-Lock® Tensioner with Threaded Bolt is an exposed, swageless, tensioning, face-of-the-post- mounted fitting that is suitable for use on level runs only, and is available for 1/8" & 3/16" diameter 1x19 stainless steel cable.
The Push-Lock® Tensioner with Threaded Bolt can be used with any fitting on the opposite end of the run. This fitting consists of two separate pieces: the threaded bolt and Push-Lock® tensioning body. The threaded bolt is installed into a pre-drilled and tapped hole in the end post. The cable attaches to the fitting via our Push-Lock® locking wedge system which requires no special tools. The body threads onto the other end of the bolt, connecting the two pieces. Tension is created by securing the post-side segment of the body onto the machine threads while preventing the cable-side segment of the body from turning.
|
|
|
